< Bath Waste & Overflow
Key Features & Benefits
|Kit Type:||Half Kit|
|Connection Type:||Solvent Weld|
Technical Resources (4)
Available in 6 variations
Frequently Asked Questions
There are four materials to choose from: 17 gauge brass tubular Polyethylene plastic tubular PVC full and half kits ABS full and half kits
How is a bath waste/overflow tested for leaks after installation?
If you are just replacing an existing bath waste/overflow with a new one, a draining test will work. This test is completed by closing the stopper and filling the tub with cold water until it starts to flow through the overflow plate, and then shut off water and inspect all connection points behind the tub. Use cold water for energy savings. If the bath waste/overflow are part of a larger plumbing system installation, reach out to your local building officials to find out what type of test is required.
When are brass side outlet or direct drain Uni-Lift bath waste/overs used?
These styles of bath waste/overflows are installed when the wood framing of the home is centered directly below the vertical drop of the overflow tube, and the project requires a brass waste/overflow. These two options allow for the tub trap to be located directly below the stopper or offset to the side. The wood framing should never be cut out without approval from a local building official because it could weaken or cause collapse of surrounding floors and walls.